| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Fancy Backstrap... http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=45325 |
Page 1 of 1 |
| Author: | sdsollod [ Wed Mar 11, 2015 1:59 pm ] |
| Post subject: | Fancy Backstrap... |
Can someone demonstrate how this is done? I assume that the backstrap wood is glued into an area that is cut out and then carved. I'd love to see some photos of this process if anyone has any... |
|
| Author: | ballbanjos [ Wed Mar 11, 2015 3:26 pm ] |
| Post subject: | Re: Fancy Backstrap... |
Here's a link to an earlier thread where I posted some pictures of my backstrapping process (it's down the page a bit): http://luthiersforum.com/forum/viewtopic.php?f=10101&t=33971&hilit=backstrap I use a drum sander to cut a flat spot into the neck shaft the thickness of my final veneers, leaving a rounded, tapering towards the back of the neck exit point on the neck blank. I then use a vacuum bag to lay the veneers in place--a good foam caul and clamps will accomplish the same thing. Then I carve the neck, making sure that the backstrap lines stay nicely shaped and parallel. Hope this helps. Dave |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|